Home > Electrical > Gauges >

TACH-12 Volt Sea Ray replacement gauge, Tachometer 5" Gas engines 6000 rpm 1291392 86297

Alternative Views:

Our Price: $204.53

Product Code: GAUGE TACH 69833


Original Sea Ray Legend Series Replacement Instrument

  • PLEASE BE SURE TO ORDER THE CORRECT SIZE! This gauge measures approximately 4-3/4" outside diameter. It has a 4-3/8" cutout diameter. This is referred to as a 5" gauge in Sea Ray parts manuals and in the marine industry. This fits most boats 38' and above. However the 37-42 Aft Cabins and the 40 Sedan bridges use the smaller 4" tachometers
  • Stainless Steel Polished trim ring - The photos sometimes make the trim ring look black
  • 12 Volt.
  • Original replacement gauge for most Sea Ray boats from the mid 1990's through 2002ish. These are exact replacements aside from the absence of the small "SR" logo toward the bottom of the dial.
  • Stainless steel trim ring. Also a direct replacement for the earlier gauges that had black or gray plastic trim rings.
  • Replaces Sea Ray part #'s 1291392 912519 0912519 , Old Teleflex part# 86297 (printed on the side of the gauge)
  • 0-6000 rpm Tachometer for gas engines.
  • Digital LCD hour meter.
  • These are brand new gauges with warranty.
  • If your replacement gauge does not operate properly, double check the connections. Occasionally, the terminals on the back of the gauge will be labeled correctly, but they will be in reverse position from the gauge that you are replacing. Do not discard your old gauge until you have verified proper operation.

Average Customer Review: Average Customer Review: 3 of 5 3 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
1 of 5 2ea purchase of 5" Tach September 28, 2021
Reviewer: Don Teston from Gulf Breeze, FL United States  
Tried multiple time to get the right mounting bracket but have never received the right one. Did receive a 5" bracket that was to short and then received a bracket for a 3 or 4" gauge that was also wrong. Requested for correct mounting bracket a third time and never heard anything back

Was this review helpful to you?

  0 of 0 people found the following review helpful:
5 of 5 Sea ray 5" Replacement Tach fir 1991 390EC September 13, 2021
Reviewer: John Linsey from Grand Rapids, MI United States  
Ordered two of the replacement tach 2nd day FedX.  Arrived on the second day as promised.  Installation took about one hour.  The port side was done in 15 minutes but the starboard side SEND wire had to be lengthened.  Please Note:  The gauge is almost identical to the original with the following acceptations:  the IGN and SEND posts are reversed from the OEM.  Starboard SEND wire had to be lengthened.  The GND post was on the outside of the IGN and SEND posts, not on the inside as shown in the picture.  The depth of the gauge housing is twice as deep as the OEM, which did not create any problems for this installation.  Adjusting to 8C (cylinders) and 4P (pulses) for each was all the adjustments that had to be done.  Other than the cost, they are great tach's.

Was this review helpful to you?

Browse for more products in the same category as this item:

Electrical > Gauges
Gauges > Legend Series