Correct Craft swim platform
Imperfect, blemished, used -Teak swim dive platforms: Original equipment on Correct Craft competition ski boats.
Ski Nautique. They can be easily modified to fit most any boat. Each strip of 3/4"
thick teak is attached to the 3/4" thick support structure with
stainless steel screws. Total thickness is 1-1/2".
This unit is a new, never finished unit. You will need to sand the surface and edges to make them smooth. Water stains remove easily with sanding and wire brush. There is no damage, no cracking. There may be some gaps between planks and support structure that need to be filled with putty. This is natural for all teak swim platforms. We have a few of these and you may not get the exact one pictured. They are all of exact equal quality.
If you need a flat transom rather than the curved
transom, simply remove 1 or 2 of the strips and then trim the support
structure. You can also trim the edges to make a narrower platform.
Overall width - 61"
Depth - 23-5/8" (the arc is not included in the depth
measurement.) In other words, if you make the platform straight, you still
have the same depth measurement.
Arc - 4-1/2"
Notches: approximately 23" center to center. Notches begin 15" from the side and the notch is 8" wide. If you measure from edge to edge, the measurements are 15", 8"notch, 15", 8" notch, 15" (adds up to 61")
Shipping is $110 to most places in the